Does Drip Edge Go Over Or Under Felt Paper Does drip edge go over or under felt? according to most building codes and manufacturer recommendations, the drip edge should be installed beneath the underlayment along the eaves of the roof. but over the underlayment along the rake edges of the roof. understanding the proper way to install the drip edge will only get you so far. It depends on where the drip edge is. at the side, or gabels, of a roof, the drip edge goes over the roofing felt. at the bottom of the roof, the drip edge goes under the roofing felt. i have no idea why ask this old house did the drip edge the way they did.
Does Drip Edge Go Over Or Under Felt Paper If the drip edge is along the eaves of the roof, it goes underneath the felt underlayment. when the drip edge is along the rake edges, it is placed over the felt paper underlayment. Many homeowners raise one question: does the drip edge go under or over the tar paper? the international building code specifies that drip edge shall be provided at the eaves and rake edges of shingle roofs. on the eaves, the underlayment shall be installed over the drip edges. on rake edges, the underlayment shall be installed under the drip edge. Tar paper goes under the drip edge along rake edges. wsu sometimes goes over the drip edge along the eaves edge in the case of mineral surface products but grace ice and water shield goes under the drip edge and down onto the facia board 1 2" then the drip edge goes over. The best way to install the roof drip edge is first along the eaves by placing an ice and water barrier over the drip edge flashing. this will enable any water on the roof to run down the underlayment, thereby protecting the roofing.
Does Drip Edge Go Over Or Under Felt Paper Tar paper goes under the drip edge along rake edges. wsu sometimes goes over the drip edge along the eaves edge in the case of mineral surface products but grace ice and water shield goes under the drip edge and down onto the facia board 1 2" then the drip edge goes over. The best way to install the roof drip edge is first along the eaves by placing an ice and water barrier over the drip edge flashing. this will enable any water on the roof to run down the underlayment, thereby protecting the roofing. Welcome to the forums! the drip edge should go on first. if when water gets to the roofing felt you want it to run off of the roof, not get trapped under the drip edge. it's ok to install the drip edge over the felt on the sides of the roof. Does the drip edge metal go under the tarpaper, ice and water shield, or underlayment on the eave? get the real story about drip edge placement. as seen in m.
Does Drip Edge Go Over Or Under Felt Paper Welcome to the forums! the drip edge should go on first. if when water gets to the roofing felt you want it to run off of the roof, not get trapped under the drip edge. it's ok to install the drip edge over the felt on the sides of the roof. Does the drip edge metal go under the tarpaper, ice and water shield, or underlayment on the eave? get the real story about drip edge placement. as seen in m.
Drip Edge Over Or Under Felt Why It Matters Roof Hippie Helpful
Drip Edge Over Or Under Felt Why It Matters Roof Hippie Helpful