Serial Monitor Strange Behavior On Esp32 Programming Arduino Forum After uploading (which is over the usb serial) and resetting the board, the serial monitor takes about a second to re acquire the serial connection. dunno if anything can be done to improve this. when the esp32 starts, its bootloader prints some diagnostics, always at 115200. Serial monitor strange behavior started after recent updates postby rodd01 » wed oct 30, 2024 5:52 pm i have a setup where an esp32 doit dev board rev1 is connected to a tft display and an nrf24l01. the objective is to receive sensor data for remote units via radio and display these values.
Strange Graph Appeared In Serial Monitor 3rd Party Boards Arduino Forum The arduino ide i’m using is 2.1.0 and i checked three different esp32 ( in arduino ide i’m using them as esp32 dev module) but the very strange fact is that today serial monitor is working as expected and all the serial.print commands i put in the setup are properly displayed but two conditions seem needed to be met:. With both serial.begin(115200) and the serial monitor at 115200, some english chars were printed and most of them were unwanted weird chars. the issue in my case was that the ground pin of the esp12f was not connected to the ground pin of the ftdi usb to serial converter. Hi, i am trying to get my arduino uno rev 3 to print out to the serial monitor. i am always getting some strange characters instead of what i want to print out. i have searched and found several similar threads about this but i didn't find any help that worked so far i have tried: trying on 2 different computers trying on 3 different os installations (2 windows 10 and 1 fedora linux, 2 of. Re: esp32 c3 development board wont print to serial monitor postby stillr » fri mar 31, 2023 8:54 am i had the same problem when i tried my first luatos esp32c3 board yesterday. but at first i was not even sure if code was uploaded correctly to the board. i didn't see any indications of problems in the arduino ide (using v. 2.0.4, on win11 pc).
Strange Signs From Serial Monitor On Ide Ide 1 X Arduino Forum Hi, i am trying to get my arduino uno rev 3 to print out to the serial monitor. i am always getting some strange characters instead of what i want to print out. i have searched and found several similar threads about this but i didn't find any help that worked so far i have tried: trying on 2 different computers trying on 3 different os installations (2 windows 10 and 1 fedora linux, 2 of. Re: esp32 c3 development board wont print to serial monitor postby stillr » fri mar 31, 2023 8:54 am i had the same problem when i tried my first luatos esp32c3 board yesterday. but at first i was not even sure if code was uploaded correctly to the board. i didn't see any indications of problems in the arduino ide (using v. 2.0.4, on win11 pc). I have the same problem, my program c on arduino ide doesn't restart when i press the reset button unless the serial monitor is put on. board: adafruit feather esp32 s2 reverse. Author topic: esp32 mirror serial monitor to lcd (read 1300 times) 0 members and 1 guest are viewing this topic.
Repost Serial Monitor Showing Strange Values Programming Arduino Forum I have the same problem, my program c on arduino ide doesn't restart when i press the reset button unless the serial monitor is put on. board: adafruit feather esp32 s2 reverse. Author topic: esp32 mirror serial monitor to lcd (read 1300 times) 0 members and 1 guest are viewing this topic.
Strange Serial Monitor Message Programming Arduino Forum